HEBEIOUTAI ENVIRONMENTAL PROTECTION EQUIPMENT CO.,LTD.

DMF-Z Right Angle Electromagnetic Pulse Valve

DMF-Z Right Angle Electromagnetic Pulse Valve
Similar Products
  • Double Axis Dust Humidifier

    The biaxial mixer uses two symmetric screw shafts to rotate synchronously. It transports dry ash and other powdered materials while mixing with water to evenly wet the dry ash powder materials so that...

  • XLD Unloader

    XLD unloader, also known as electric unloading valve, electric airlock, this device is dust removal equipment, conveying, ash discharge, wind lock and other equipment feeding the main equipment, suita...

  • Polyester Acupuncture Felt Bag

    Polyester needle felt dust bag in addition to a common felt-type filter cloth unique high porosity, good air permeability, dust collection efficiency, long service life. Polyester needled felt dusting...

DMF-Z Right Angle Electromagnetic Pulse Valve Product introduction:

The electromagnetic pulse valve is imported from abroad (also known as the diaphragm valve) is the compressed air "switch" of the pulse bag filter dust cleaning system is controlled by the output signal of the pulse injection controller, and the filter bag is cleaned by the row (chamber). Ash, so that the dust collector's resistance is maintained within the set range, in order to ensure that the dust collector processing capacity and vacuum efficiency.

DMF-Z Right Angle Electromagnetic Pulse Valve Features:

The DMF-Z electromagnetic pulse valve is a right-angle valve. The right angle pulse valve between the inlet and outlet is 90°. It is suitable for the mounting connection between the helium cylinder and the dust blower tube. The gas flow is unobstructed, and it can provide the turbulent gas flow that meets the requirements.

DMF-Z Right Angle Electromagnetic Pulse Valve working principle:

The diaphragm divides the electromagnetic pulse valve into two air chambers, front and rear. When the compressed air is turned on, the compressed air enters the rear air chamber through the throttle hole. At this time, the pressure of the air chamber presses the diaphragm against the output of the valve. The pulse valve is in the "closed" state.

The electric signal of the pulse injection controller causes the electromagnetic pulse valve armature to move, the air chamber vent hole opens after the valve, the rear chamber quickly loses pressure, the diaphragm moves back, the compressed air is blown through the valve outlet, and the electromagnetic pulse valve is "opened" status.

Pulse injection control instrument electrical signal disappeared, electromagnetic pulse valve armature reset, after the air chamber vent hole closed, the rear chamber pressure increased so that the diaphragm close to the valve output, the electromagnetic pulse valve is in the "closed" state.

If you are looking for diaphragm valve manufacturers, Senotay can be a competitable one among those diaphragm valve suppliers. Contact us to get more information about our products!
Leave us Message
  • TEL:+86-15831871808
  • FAX:+86-0317-8288592
  • EMAIL: info@senotay.com
  • ADDRESS:Botou Industrial Zone, Cangzhou City, Hebei Province